There are residential roof anchors and commercial roof anchors.
Roof truss anchors.
A spreader braces the trusses and distributes arrest forces across several trusses.
Timberlok replaces 3 8 lag screws and is approved for use in acq pressure treated lumber.
Framing anchors connect various trimmed openings and elements in the ceiling joist structure.
Truss clips hold truss or rafter to the wall plate.
The embedded truss anchor series provides an engineered method to properly attach roof trusses to concrete and masonry walls.
The products are designed with staggered nail patterns for greater uplift resistance.
The snappy roof anchor meets all applicable standards for fall arrest.
When making a selection below to narrow your results down each selection made will reload the page to display the desired results.
Types of framing anchors shown above available at insulation shop.
Embedded truss anchor 12 girder tiedown 6 hurricane gusset angle 2 masonry uplift connector 2 moisture barrier plate 3 rafter tie 29 uplift girder ties 24 series.
If all you have to anchor to is a naked truss these anchors will do the job.
Dual framing clips left and right grip framing anchor type a left and right.
There are concrete decking anchors and metal decking anchors.
There are disposable anchors and there are anchors for permanent or temporary installations.
Bare wood truss anchors these fall protection anchors are designed to attached directly to a wood truss.
Embedded truss anchors and truss seat snap in an engineered method to attach roof trusses to concrete and masonry walls to resist uplift and lateral loads.
They can be reused according to the manufacturer s instructions.
Staggered nail patterns provide greater uplift resistance.
These anchors do not penetrate the roof sheathing they do not pass go and they do not collect 100.
Timberlok is a heavy duty wood screw for applications such as attaching rafter or trusses to the top plate landscape timbers fences decks headers stair stringers and more.
3 8 lag screw replacement.
Into a poured concrete bond beam or grouted block wall staggered nail pattern for enhanced uplift resistance.
Spreaders can act as anchors for personal fall arrest systems and fall restraint.
They provide an anchor point for fall arrest systems on roofs for maintenance work repair and new construction.
These roof anchors are easy to install by nailing into the truss and easy to remove by hammering over the attachment point when the job is done.
There are anchors specifically designed for installation on wood metal or concrete surfaces.
It is important to refer to the truss manufacturer s instructions and have a qualified person determine if trusses will meet strength requirements for a personal fall arrest system or fall restraint system.
Permanent roof anchors are designed to provide one d ring anchorage point when installed securely on a wood roof sub surface or vertical wall.
There are permanent and reusable options available.
