Striations and bends on the flashing provide strength and match the lines of your other edge trims.
Roof sidewall flashing.
The flashing extends onto the roof a minimum of 2 inches 4 inches is preferable in more severe climate areas.
It s a standard l trim and we use this trim most often in a concealed or hidden fastener application.
The universal sidewall trim combined with sealant provides a watertight seal for your roof system.
Flashings shall be installed at wall and roof intersections wherever there is a change in roof slope or direction and around roof openings.
Installing step flashing to prevent roof leaks step flashing spans the joint between roof shingles and an adjacent side wall.
Details concrete masonry roofing wrb flashing.
Flashing joints are lapped 6 in the direction of water flow.
The wall side of the flashing can either be covered over with siding or sealed with caulk.
One common method is to lay the edge metal under the eaves membrane and over the rake.
Epdm flashing tape with a butyl adhesive backing will help.
I m going to mark the reverse side of it for the sidewall and mark where it finishes at the end of the panel for bending down.
I m going to put it up against the wall so that i can make my marks.
Butyl tape should be applied where the foot of the flashing attaches to the roof.
The extra kick at the bottom of the face directs run off away from the structure.
Vent flashing done right to prevent leaks back up roof vent boots with flashing counterflashing and proper shingling.
More product details close.
Here s how to install it correctly.
The flashing shall be a minimum of 4 inches 102 mm high and 4 inches 102 mm wide.
This drip edge flashing provides protection from water damage along the eaves and rake of a roof.
Protect the eave from ice dams and sideways rain step one in steep slope roofing is the edge flashing.
Two ways to flash roof edges.
A flashing shall be installed to divert the water away from where the eave of a sloped roof intersects a vertical sidewall.
Proper installation of flashing and counter flashing at the intersection of a vertical wall with a roof surface is required to avoid roof leaks.
Universal sidewall trim is designed to flash from your metal roof panels to a vertical wall such as a chimney.
Our page top photograph illustrates a successful installation of flashing and counter flashing along intersection of a roof surface with the side of a brick constructed dormer.
Flashing against a vertical sidewall shall be by the step flashing method.
The metal flashing is formed with a hook edge and cleated on 12 centers.
Sidewall flashing sidewall flashing is applied when the side of the roof butts up against an adjacent wall.
The flashing extends up the wall at least 4.
