Now that the roof is applied it is much more difficult invasive time consuming to install the drip edge being 3 stories only makes it much worse.
Roof drip edge installation after shingles.
The starter course is comprised.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
4 deep nail the drip edge to the sheathing every 16 if installing multiple runs of drip edge lap them by 1 4 1 2 inch keeping the nail back from the lapped joint.
Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and.
Once all the underlayment is applied go back and place.
Make sure the outer edge extends over the gutter.
Gently slide the flatter side of the drip edge under the eave.
Drip edging is a strip of flashing that is applied to the edge of roofing prior to the installation of other items.
Install roof drip edge along the eaves add underlayment then place drip.
This will allow for expansion and contraction and prevent buckling.
Using drip edge with a nailing edge approx.
Install the starter course.
Once free slide the drip edge out and discard.
Select enough lengths of.
Be sure to tuck the drip edge under the starter strip and felt paper.
Use a flat pry bar and hammer to pry the nails out of the drip edge gently.
How to install a drip edge.
Using a utility knife cut back the front end of the drip edge.
Save yourself some.
Slowly lift a shingle that is closest to the apex of the roof.
Secure the drip edge with roofing cement.
Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
How to install drip edge flashing on a roof step 1.
Windy september 22 2017 4 11pm 10.
Slide the corner tight to the fascia.
It is designed to protect the roof s sheathing from water damage caused by rain snow or ice being blown or rolling back beneath the edge of the shingles.
You may need to nail through the starter strip into the drip edge.
How to fix a roof drip edge installing roof drip edge flashing properly.
Place the metal roof drip edge flashing along the gable ends.
Place a nail at one end then the other.
If it doesn t pull the drip edge out slightly from under the shingles.
It can be done.
Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.
The way your sheeting is on top of the sub facia requires a drip edge to cover it so that the edge of the sheeting doesn t wick moisture into it.
